monte12345
Senior Member

- Used DXO Photolab 9 to apply a light touch of Noise Reduction because I had the camera set to ISO 800 because of no VR and I am not as steady as I was 20 years ago. Lens used was my 105mm f2.8 Micro Nikkor D (pre VR).
- Then I opened the file in Airty Image Enhancer set for 2X linear upsize and 2 pass enhancement.
- Opened the file in Corel Paintshop Pro to lighten the image a bit along with a light touch in saturation and contrast. Could have done that at the start in DXO but was a bit too focused on doing the Noise Reduction and really didn't look at the image until after the upsize.

100% crop

200% crop
These do indicate this image will print quite well.
Last edited: