Hi,
Noticed last night a stuck red pixel very close to the centre point, was obvious due to a black object. Its present at all ISO's. I looked online at how to fix, seems there are many videos which all say in summary,
- remove lens and place body cap.
- go to manual sensor clean and activate while pointing camera downward.
- wait for 1 minute then switch off.
- it should be fixed?
Tried this, no change. Also not seen any official documentation regarding this method so is it just an urban myth? Any other ideas?
I'm guessing there is an acceptable number of stuck pixels on a sensor, but how do you map them out without a visit to CPS?
Thanks
Noticed last night a stuck red pixel very close to the centre point, was obvious due to a black object. Its present at all ISO's. I looked online at how to fix, seems there are many videos which all say in summary,
- remove lens and place body cap.
- go to manual sensor clean and activate while pointing camera downward.
- wait for 1 minute then switch off.
- it should be fixed?
Tried this, no change. Also not seen any official documentation regarding this method so is it just an urban myth? Any other ideas?
I'm guessing there is an acceptable number of stuck pixels on a sensor, but how do you map them out without a visit to CPS?
Thanks
