Samsung Remote Studio NX1 v1.31 not working

[Rajminster]

I just updated to v1.31 and I can't get the Samsung Remote Studio from iLauncher to work. It brings up the message "please use body firmware 1.31 or higher" even though it says my firmware is v1.31! Has anyone else been experiencing this?

 

[Coldamus]

As discussed in the firmware 1.31 thread, you have to change the USB connection method in the camera to Remote rather than Mass Storage.

 

[MoCa]

even then it does not work :-(

 

[Hirsti]

even then it does not work :-(

it is just a message that will always pop up unless you tick the do not show again.

I have had issues on 2 different computers where I couldn't get it to work.

First was on a laptop where even though I was setting it in the camera to remote access and the laptop was recognizing the camera via usb there was no picture in the app.

I fixed this by using a different USB port and it started working.

On my desktop PC I have it connected at the moment, it connected fine initially but keeps crashing periodically with a Remote Studio has stopped working error at which point it closes itself and reopens and then starts working.

On both machines I have experienced the photo transfer corrupting the files at transfer at which point the NX1 camera locks up and cannot be used and the remote studio cannot be used either but the live feed is still there. The only way to fix this is to switch off the camera, close the remote studio and turn them all back on again.

Also I have had it a few times where it says it is transferring the files and then nothing transfers.

Hope this helps