Reading mode: Light Dark

Using DCRAW to get TIFF out of HS10 RAF

Go to last post
Hi Wolfram
And after analyzing the c-source-code of the new
version 9.00 i found now even the S200EXR which
i didn't found in the previous version 8.94 (but the
S200EXR was listed as supported even in this version
8.94!)
Regards
Bernie
 
Hi,

how long does it usually take until the dcrawMS version is published?
Helicon seems to be very comfortable to use.

Thanx
 
You can take the binaries (executable) v9.0.1 for windows and mac from http://www.insflug.org/raw/Downloads/

It's the one that says:

"[dcraw.exe] dcraw build version 9.01 Revision: 1.434 Date: 2010/05/30 15:57:43 for Windows systems, see Windows Notes. 447.50KB"

The MS Compiler compiled version it has just the potential to be faster, but last time i checked only the previous version was available
 
dcraw seems not to work on vista. Helicon is only opening the included JPG with 3 MP. How can I change that? I have copied the new dcraw.exe into the helicon folder, but that didn't help.
 
I use command line to execute dcraw under XP... in vista there shouldn't be any problem if you do the same ... about helicon, i don't know... never used it, gimp and raw therapee (uses dcraw based libraries, but not the executable) do everything i need...
 
You must log in or register to reply here.

Keyboard shortcuts

f
Forum
m
My threads
Mobile site
About
Editorial content
Cameras & Lenses
Community
All content, design, and layout are Copyright © 1998–2025 Digital Photography Review All Rights Reserved.
Reproduction in whole or part in any form or medium without specific written permission is prohibited.
When you use DPReview links to buy products, the site may earn a commission.
©GPS Media - Guides, Products, Services.
Back
Top