Charles2

Look at the page screenshot in the second post of this thread. He tells how he did it.

1. Your rant - under an obituary, no less - shows that you cannot stand someone like Benson who has an educated eye, who uses color management techniques, but who does not murder the art. 2. You ...

More on how he printed: Original Size is legible.

An obituary is at https://www.nytimes.com/2017/06/27/arts/design/richard-benson-dead-photographer-and-photo-printer.html Read below how he prints in layers. Acknowledged as one of the world's ...

You can, of course, feed a paper through whichever inlet works for you. If the P400 front feeder is like the one on the P800, I can tell you, one, it is an improvement over the rear feeder of the ...

I like rangefinder lenses. The adapter is shorter and the lenses themselves are often small. But the Takumar and Minolta lenses for SLR are fine, too. There are several dozen examples, the tag ...

Presumably you would like to free up the memory for your use, which is basically to take a few JPGs when you do not have an SD card with free space on it.

The beginner's approach to Fuji Raw File Converter: Find the Taste box at the upper left; begin with Default (later, you may wish to begin with Neutral). Then work down the column of boxes ...

Check that the port assignment is consistent. That is, compare the IP address for the printer on your router (see its webpage of Attached Devices) and as Windows has it (Devices and Printers | the ...

You didn't mention Pro Neg Hi. Tried it? Your easiest workaround is probably Fuji Raw File Converter 2. When you open a RAF in it with the "Taste" set to default, it does a pretty good job of ...

Raw Therapee comes in a Mac version.

Good to hear it was the adapter, not the lens. $60 is expensive for a generic M-mount to X-mount adapter. They are widely available for less than half that, and only one of a half dozen or more ...

I opened the raw file in Fuji RFC2. It read the Velvia setting. All I did was increase saturation from 1 to 1.06, bump contrast a notch, and increase the noise reduction a little. Nice shot, the ...

The print services I've seen do not stretch one dimension. When you set up the order, you choose either a crop that they preview onscreen or blank space (above and below, or left and right) around ...

You will get hits with this in a search engine: fuji sample raf file

Have you tried a baryta paper, for example, the one from Canson? It meets your criteria, in my opinion.

The adapter does not look thick enough to bring infinity focus down to 50 cm. The problem could be an adjustment in the lens on the focus helicoid. Here is a discussion of the problem, for a ...

Most cameras today have settings for the camera JPG, including sharpness. Some cameras have in-camera raw conversion: you can generate one or more additional JPGs from a raw+JPG shot, each with ...

Speaking of contrast issues, if you look at the first photo at full size, notice the boundaries of the man and the background. It looks 3-D but also rather artificial. The JPG was generated at 0 ...

This indicates a battery drain despite the power switch being off. If the problem were firmware, we should have heard many reports. The problem is probably a bad contact in the circuitry of the ...