tugwilson

You can always fake the lamps by hiding speedlights in the shades Gel them to tungsten. A powerful small LED light (like the Aputure AL-MX ) would probably work instead of the speedlight.

There are a series of articles on the Strobist site which cover shooting interiors https://strobist.blogspot.com/2007/07/rockin-house.html and ...

I think you are referring to the Sekonic L-478DR-EL. That has a built in Skyport trigger. It's a pretty expensive way of avoiding the minor inconvenience of holding the light meter in one hand and ...

Might be. I think you'd just have to try lots of stuff and see what works. I'm tempted to dig out my old Mamiya RB67 and the 150mm f/4.0 soft focus lens ...

Certainly not a Nano stand. I've used an AD200 on a nano stand and it's barely adequate. The B10 is 2-3 times heavier.

Seeing as you only want "George Hurrell-ish" a high efficiency reflector would probably give you nice hard light that's good enough for your purpose. Do people still put vaseline on a filter to ...

The Aputure works best with a near point light source (like the 120d). When used wide with an AD600Pro it tends to image the horseshoe element so you get uneven illumination. I use it with an ...

That looks a pretty heavy load for the stands. Have you considered using autopoles? https://vimeo.com/25116431 The manfrotto versions are quite expensive. I bought these ...

Pixapro/Essential Photo are very good. My experience of their service is very positive. They used to sell a white Mola clone but that seems to have disappeared.

I bought a Bowens BW-1899 75 degree Softlite reflector with the BW-1866 grid diffuser from Wex a while ago. (£120 for the set brand new bankrupt stock). It's a bit small for a beauty dish but the ...

I think that is very likely.

You can use Flashpoint R2 E-TTL 2.4G Wireless Flash Trigger Receivers to trigger your 630M and 320M. What mount do your Glow modifiers use at the moment?

Replace the reflector that comes with the light with a 7 inch Bowens mount reflector. Get one that comes with grids. Something like this ...

Do you have auto ISO set? If so, that's exactly what I would expect to happen. The camera is expecting the bulk of the  light to come from the strobe so it sets a constant ISO and shutter speed ...

Have you put the flash in the receiver in TTL mode? It needs to be in that mode for the receiver to control it even when using the flash in manual mode.

Godox does.  I think Nissin does for most devices but the MG10 has a Sony socket.

No, you should use full power with the Bowens light. Yes but then it's the other way round. If you want short duration you reduce the power (For most Godox lights).

QT600II is 1/316s - 1/4246s in "Stable Colour Mode" - 5600K ± 200K AD600Pro is 1/220s－1/10100s in Colour Stability Mode - 5600K ± 75K 3rd party tests of the AD600Pro confirm the ± 75K claim if the ...

With these lights the initial voltage of the capacitor is used to control the amount of light produced. The more power required the higher voltage the capacitor is charged and the more energy it ...

A reflector holder like this https://www.amazon.com/Neewer-Studio-Holder-Attachment-Reflector/dp/B016XQZZR2 should work OK.