ccarrier

usign mask or a blending mode or something else ? Thank you!

Very interesting!

Hi Andy, great explanation.  Thank you very much"  I will read the web link more toroughly when I have time. You mentionned that it is covered in the manual.  I have read it from cover to cover and ...

Hi, I looked at your video. Very interisting. Unfortunately, I can't help.  I hope that someone can. Have a good day!

Hi, The order in which things should be turned on is the following : 1) yungno transmitter 2) yungno receiver 3) camera 4) flash (they all must be in ttl mode) Have you tried it in this order ? Try ...

Hi, Have you tried half-pressing the shutter release button again after taking the shot ? Have a good day!

Hi again, Just tried it on my D750 and it does focus un live view with face detection focus.  But I can't tell for sure for the D5100. If you're willing to wait 20 days for shipping, you can buy ...

Hi, yes the ML-L3 will do autofocus if focus mode is set to AF-S or AF-A. (However, on my D750 if I do focus by half pressing the shutter button, then the ML-L3 won't autofocus.  It will take the ...

Did you change graphic card lately ? Try disabling "Use graphic processor" in the performance tab  of the preferences, and see if the problem still occurs. It will only partially solve your problem ...

Hi, I'm not an expert either. Maybe the light is too even. In the first picture I see that you have a lamp on a swivel. I would try to turn on  this lamp, to light saxophone. With the flash, I ...

Nice picture! Did you do some post processing to adjust the lighting of the foregroud and the stars or it is relativily as shot ?

Hi, from the washed out and bleeding colours of the first image, I would suspect that high ISO noise reduction was set very high in Capture NX-D. Try reducing it to see if it is better. Have a good ...

Hi, to my knowledge, the only solution is your number 1 : Remember that you have EC dialed in. Number two will work (custom setting b3 set to "on (auto reset)" only if you let the standbye timer expire

When easy ISO is ON (custom setting d8), you just have to turn the front dial  without pressing any button when in P and S mode, However, if you want to use the front dial to change ISO when in A ...

Hi, If auto iso ramp up the iso a bit further than you would normally have gone manually, it is probably because you haven't set the auto iso parameters correctly. If you want ISO to increase when ...

Custom setting d8 : Easy ISO when set to ON : Iso sensivity can be set in modes P and S by rotating the sub-command dial or in mode A by rotating the main command dial. (p. 281 of the manual)

hi, on auto iso, the iso will go up only if the speed falls below a certain treshold. That treshold can be a fixed value or a value dependant on the focal length. So I have difficulties to ...

Custom functin F5 (page 363 of the manual) The only thing I can see is that you activated "bracketing" by mistake. Have a goo day!

Placed 18^th in the challenge. Sunset and moon over Quebec city

Wow! I've never seen a challenge which such tallent all the way! congratulations to all participants!