D2X Firmware updete problem

[Gianni44]

After installing D2X Firmware update 2.0 all runs fine except the option to assign Hight-Speed Crop to FUNC button.
I set it in new FUNC. + command but it won't work as it did before.
Anybody had the same problem ?
It's my fault i have not understood the way to set it

-------
gianni44
http://www.pbase.com/owlman44

 

[frederic fahraeus]

Yup! same problem here. Dont know why though.

regards Fred

 

[tomoo1000]

Hi the only thing it seemed to do was changed the command dials back to their original orientation and reset the film counters to zero ? Other than that there has been no problems whatsoever with both the D2x & D200 firmware update's.

Phillip.

--

One's life is not measured by the two dates upon your tombstone, but how you lived the dash in between them

 

[Gianni44]

Trying and trying again finally i got the solution.

1 - go to f5 Func+command in CSM menu and check High Speed Crop;

2 - press the FUNC button and keeping it pressed rotate the Main command dial: High Speed Crop is now activated;

3 - redo n° 2 to deactivate this function.

--
gianni44
http://www.pbase.com/owlman44

 

[Hamstor]

It is set in the function + Command dial option.

You can't change to HSC mode just by pressing the FUNC button.

Installing the firmware resets these setting so you need to assign it again.

 

[Foxie]

Trying and trying again finally i got the solution.

1 - go to f5 Func+command in CSM menu and check High Speed Crop;

2 - press the FUNC button and keeping it pressed rotate the Main
command dial: High Speed Crop is now activated;

3 - redo n° 2 to deactivate this function.

--
CHEERS!

• Please visit my portfolio @ http://www.photosteron.com *

 

[ChuckNance]

After installing the FirmWare update on my D2X my Tokina 12/24 goes 'rrrrrrrrrrrrr' and won't focus.

 

[johnspijk]

Thats strange, after reading your post I tried my Tokina and it focusses fine.

 

[ChuckNance]

Strange,.. I took the Tokina off, put a Nikon 17/55mm on, changed it back, fiddled wit the AF and MF on the lense and now it works fine...

What a relief!

 

[Grzzl]

Maybe the contacts must be cleaned.

 

[carsten böttcher]

It's not the firmware it's that what the Tokina 12/24 always does when it's not handled like a raw egg. Just dismount/mount or AF/MF it.

 

[roadrats]

After the Firmware upgrade Nikon view reports: "Auto Flash Mode: Optional TTL " After update view from version 6.2.5 to 6.2.7 it shows Balanced i-TTL

But no longer the info "Auto Flash Comp: " It is gone in 6.2.7 !

In Capture NX 1.0.1 - 15247 also: "Auto Flash Mode: Optional TTL-BL "

"Auto Flash Comp: " is oke in Captute NX and also Sensitivity like 0.7 EV over 800

Other have the same ?

Thanks

Jan (The Netherlands)
--

Some of my pictures with the D2X

http://www.xs4all.nl/~roadrats/D2X/D2X.html

and with the good old D100

http://www.xs4all.nl/~roadrats/Nikon/Nikon.html