LR 5 clone heal tool
The clone heal tool will function on the whole area of the image.
when I move to some locations it goes away, then when I move back the tool reapears in the location I was in.
I never had this problem in LR4
for some reason the clone or heal tool will function in some areas of the raw image
1. The clone cursor disappears. When i am on the full size image there is an area that it will not show. If i zoom in on area that it did show before there is still some of the zoom area that it disappears.
3. if i move to that area an arrow points to the section that it would appear.
IF I USE the brush tool and darken or lighten it will not function in this dead area, but if I start out in the area whre the brush is seen and move into that area, the dead area will show the lighten or darken with the brush
The clone heal tool will not function on the whole area of the image.
A simple restartof LR
|_F0A5334-Edit_small by Dester Wallaboo|
from Open Air Fashion Photography
|Feed me, me, me, me, me by Denjw|
from Attention-Seekers in Nature