DPReview.com is closing April 10th - Find out more

3D-Printed Anaperture Single-Shot Anaglyph Aperture

Started May 21, 2016 | Discussions thread
3D Gunner Senior Member • Posts: 1,031
Re: 3D-Printed Anaperture Single-Shot Anaglyph Aperture

ProfHankD wrote:

  1. Use a lens that doesn't vignette. FF lenses are a better bet for APS-C than ones designed to just barely cover APS-C, but lenses vary a lot.
  2. Make the pair of apertures fit within the smaller non-vignetting aperture size.

Still, your shots don't look bad.

1. The lens used is a very good one, for FF cameras.

2. I will also do some tests with 5mm holes 4mm apart (9mm separation).

I currently use a device with two lenses with an inter-axial distance of 9mm, for 3D macro, half a frame for each eye.
Using this procedure, I expect to be able to obtain a better image quality in terms of resolution, but with severe limitation to the anaglyphic mode and a lack of uniformity in terms of horizontal color distribution.

Post (hide subjects) Posted by
Keyboard shortcuts:
FForum PPrevious NNext WNext unread UUpvote SSubscribe RReply QQuote BBookmark MMy threads
Color scheme? Blue / Yellow