Is there life after aperture block failure?

TacticDesigns wrote:

Massao wrote:

peterpainter wrote:

Futax wrote:

You could also try using Av mode. On my K-50, the camera still stops down the aperture as defined by the ring. Since the camera doesn't actually know that aperture, you need to get it to provide the correct exposure, and you can do that by using exposure compensation. If you're shooting wide open, then exposure is correct without compensation. Otherwise use the appropriate compensation.

Seems to be a much more accurate method for getting the correct exposure than using the green button in M mode. Also, can make shooting off several frames a lot quicker.

The camera is pretty-much always et on AV mode and was when I was getting odd exposures using just the shutter button rather than the green button. As I mentioned in another comment, I'll experiment further but from limited testing today the green button seems to work better - and frankly, I can't understand why it should!

Ok, then I wonder whether you have done these changes in settings as recommended by PF. See here .

If your Aperture Block failed, will stopped down metering work with Pentax-M or Pentax-A lenses?

I was just thinking about that.

I pulled out my Pentax K100d and tossed a Pentax-M lens on it.

To do stopped down metering, since I don't have a "Green" button, I push the AE-L button instead.

But . . . I can hear the lens being stopped down.

If the Aperture Block motor has failed, how can the camera stop down a Pentax-A or Pentax-M lens?

Take care & Happy Shooting!

I think the only way would be to do stop-down metering on A and M lenses (but I don't have any that I can test with) -  can't see how the camera could set the aperture.  I'm using it (stop-down metering) with my screw mount (Carl Zeiss Jena) lenses and it's a pain, really, but I suppose people got used to it in the old days.