DPReview.com is closing April 10th - Find out more

a7RII+Meikon Case+ST-100 Strobe

Started Jul 14, 2018 | Discussions thread
daveco2
OP daveco2 Contributing Member • Posts: 953
Re: a7RII+Meikon Case+ST-100 Strobe

Guzy,

Looks like you're getting close. To use that gland, you just have to be sure that it protrudes far enough into the case to put the nut on it, at least 0.365". If it doesn't, you could grind off some of the case inside surface, making sure to leave enough for wall strength. Below are more dimensions for you to check. 14 mm (0.551") is close to the 0.535" hole diameter, so the gland may fit with minor mods, except for the two flats which may have to be ground off if the gland outside diameter is larger than 0.792". Time for some precise measurements of the gland.

If the dimensions check out, all you would need is to clear the gland internals and epoxy in their place a piece of transparent plastic. I could make that for you.  I'm assuming you have the fiberoptic external and internal connections worked out.

Gland parts as they would fit into the Meikon electrical fitting hole. Note required gland thread length and diameter.

Meikon case with electrical fitting exposed. Note flats on O-ring seal surface.

 daveco2's gear list:daveco2's gear list
Sony RX100 Sony a7R II Sony a7R III
Post (hide subjects) Posted by
Keyboard shortcuts:
FForum PPrevious NNext WNext unread UUpvote SSubscribe RReply QQuote BBookmark MMy threads
Color scheme? Blue / Yellow