Experts.. Is this possible!?
First off, I greatly apologize if this is the wrong section to post in..
Hello good people of DP! It seems as if a lot of print savvy people are here and hopefully someone can guide me in the right direction because I am more than lost. I am about zero for hundred in finding a solution. So here it is.
I am in the midst of a project I have been developing for the past 6 months and have came across a giant obstacle. I am trying to get multiple colored patterns printed on a shoe lace aglet (The fastening tip at the end of a shoelace) The aglets could be basically any medium (plastic, metal, brass, aluminum) really anything that works for the printer.
Ideally I wanted to print already on a pre rolled aglet otherwise if I printed on a sheet and then rolled the aglet i would have to deal with the print rubbing off or cracking. Is there any printer or technique that can handle printing on a small tubular piece such as an aglet?
I seriously do appreciate the thought and time to read this. Thank you!!
|Thunderheads With Egret by Buzz Lightyear|
|Double Rainbow; Abiquiu, NM, USA. by abiquiuense|
from After the Rain