Re: developer menu settings in firmware.
PDM
wrote:
Thanks, shows total actuations too
Any idea what Line Process Step, Line Process Mark do? I think my Line Process Mark was at 1 by default?
my nx200 has 'line process step' off
and 'line process mark' is set to 7
and from the service manual, they call this tester mode. The Contents Of Tester Mode. (table 7-2)
Menu
Detail menu
Function
1. FW UPDATE
(1) BODY FW UPDATE
(2) LENS FW UPDATE
(3) EXT. FLASH FW UPDATE
(4) DSP FW UPDATE
(5) RESET USERDATA
Do the upgrade firmware for each section.
It’s only CS firmware not customer’s one.
Update display screen.
2. SYSTEM PARAMETER
(1) FACTORY RESET
(2) POWER OFF TEMP.
(3) DISABLE CHINESE LANG
(4) DISABLE DISPLAY SEVE
(5) DISABLE POWER SEVE
(6) DISABLE MOVIE REC LIMIT
(7) NO LENS RELEASE ENABLE
(8) DISABLE INT ERR POWER OFF
Factory reset mode setting.
3. ADJUSTMENT CONTROL
(1) AUTO START DISABLE
(2) PTP AUTOMATION ENABLE
(3) LINE PROCESS STEP
(4) LINE PROCESS MARK
(5) ADJUST DATA TO LOG FILE
(6) ADJUST RESULT
(1) Prevent auto start mode when insert the adjustment file.
(2) USB terminal PTP as recognized.
(3) Setting of each adjustment procedure.
(4) Confirm the former adjustment whether it is finish or not.
(5) Save the result of adjustment.
(6) Confirm the result of adjustment.
4. LENS CONTROL
(1) OIS ADJUSTMENT
(2) ZOOM WIDE SET
(3) ZOOM TELE SET
(4) MR SENSOR ADJUST
(5) LENS MOUNT INFO
(6) LENS COMM SEVE
(1) OIS lens adjustment.
(2) Fix the wide value of zoom lens.
(3) Fix the tele value of zoom lens.
sorry for the poor table conversion, the main headings Menu, Detail Menu and Function are three columns populated respectively with the above details.