My model looked at me like I was crazy when we drove to a grimy alleyway behind an Italian grocer because I wanted to shoot 'a pretty summertime editorial look'. While I can hardly blame her, I live and work in Seattle, which can certainly live up to its overcast and rainy stereotype. So, I sometimes find myself in a certain mania to use the sun while it's out.
In this article, I'll walk through a quick and simple look where minimal lighting and a bit of color were used to turn our spot in the grocer's alley into a fashionable set - no studio required. In particular, we will look at how the shot was built up to allow creative control in a mixed-lighting situation, using a combination of external flash and available light.
There were a few challenges for this shoot. The location was certainly not 'naturally beautiful'. I was shooting in a sedan, which is a fairly constrained space. It was late afternoon. As daylight time was short and I didn't have an assistant with me, the lighting equipment needed to be simple and easy to set up.
|As locations go, this is about as un-glamorous as they get.|
Why this particular location, sandwiched between a dumpster and a crooked cyclone fence? To build up this look, I wanted to start with 'open shade' - a location that was open to the sky but not in direct sunlight. This gives the background a soft, even light. This was important because I was using external flashes as the main light source; having even light in the background meant that I could set my exposure without worrying about blowing out parts of the background scene.
I was also planning on shooting with a wide aperture to allow the background to blur nicely. The fence, when shot out-of-focus, would provide a fairly interesting visual texture, and the rest of the alley wasn't even going to be in the shot. Most importantly, however, this alley is not a high-traffic location, so I would be able to set up the car and lighting without disturbing anybody or getting passers-by in the photos.
|This is a test shot showing the look using only available light with no |
f2.5, 1/80 @ ISO 200.
In the image above note the difference in exposure between the model's arm, which was near the window, and her face, which was in the full shadow of the car. This would be difficult to adjust for without external lighting. Ideally, aside from edge lighting, the model's face would be as bright or brighter than the parts of her body that are in the background. If I hadn't augmented the available light with an artificial light source, the images would be very soft and flat, as in this example. Recall that I was shooting inside a sedan that itself was in open shade. This is an environment with very diffuse, low-contrast light. By the same token, however, this provided an excellent palette for constructing my own lighting setup.
To maximize the effect of the available light and throw the background out of focus, I was shooting with a very wide aperture, f2.5. This can be dangerous territory when photographing people. At f2.5, depth-of-field gets very shallow, particularly for subjects that are close to the camera. Slight movements by the model or the photographer can be enough to throw off critical focus. However, as this was a candid and fairly casual look - one that probably wouldn't be printed at 24 plus inches and hung in a gallery - coming away with something less than an absolutely tack-sharp image was not going to be a deal-breaker.
My lighting kit for this shoot was a pair of Metz Mecablitz 60 CT-4 flashes that I had borrowed from an assistant. This is a 2000's era flash system which has some very handy features for situations like these.
Most significantly for this shoot, the units can be hooked up to regular sync cables without requiring expensive adapters. This meant that I could fire the flashes using standard radio triggers - the kind that I already had lying around the studio. This gave me a tremendous amount of freedom in placing the flash heads. I could set one unit behind the model to provide backlight and one unit behind myself, facing the model as a key (main) light.
This is an arrangement that could be very difficult to trigger using a line-of-sight infrared system such as those built into dedicated speedlights. Additionally, the Metz flash units provide an audible recycle indicator - they 'beep' when they're ready to fire again. This was a useful feature since I was placing the flashes behind my back and behind car doors, where it would be difficult to see visual LED recycle indicators on the flashes themselves.
A car can be used as a quick and easy set, but photographing a person inside a car does present some difficulties. There are a limited number of places where the photographer can go. Using a large car or one with very adjustable seats can give you more possibilities for situating yourself. There are likewise a limited number of locations where lighting can be placed - nominally, pointing in through the car's exterior windows. To get around this, lights could be boomed in through an open window or held by an assistant if necessary.
For this shoot, I wanted the background light to be directly behind the model, pointing towards the camera. I put the light on a stand aimed through the passenger-side window, behind the model and about two feet away from the car. This created a strongly backlit image, picking up color in the hair and putting lighting artifacts (glare) in the frame.
In order to avoid the temptation to zoom out and capture more of the model in my frame, I used a 50mm prime lens for the shoot (65mm equivalent focal-length after crop factor on my APS-H sensor). This was wide enough to get an acceptable amount of the environment and create some separation between the subject and the background, but not wide enough to cause unflattering wide-angle distortion of the model's features, which would have been a risk if I was using a zoom lens and zoomed out too far.
The background light alone did not help to open detail in the model's features, so I added a second flash as a key light to illuminate the model. This flash was about 3 feet behind my shoulder, firing through the open driver's side door of the car. However, the raw flash looked too flat and harsh for my intended treatment. Further, I originally set the flash to be about a stop brighter than the ambient light. This gave the image an obvious 'artificially lit' look.
To remedy this, I lowered the flash's power relative to the ambient light and covered the raw flash bulb with the unit's built-in diffuser. I also moved the flash closer to the model. This slightly increased the size of the flash relative to the subject, which further softened the quality of the light. This diffused light was gentle and closer in intensity to the ambient light, which made the lighting look more believable and natural.
Note that I introduced the background light before adding the key light. The background light has a less significant overall effect on the image; I often find it easier to visualize the contribution of lights going from darkest to brightest. The dim lights take back stage after the big lights are added; if I had started with the key light in place, I might have mistakenly tried to adjust this image by lowering the background light.
The main light has been corrected.
than the ambient light. At this ratio, the key light is providing a strong
fill without overpowering the natural light.
I had fairly limited options as to where the key light could be placed. If the key light were aimed through the windshield or rear window of the car, the model would have had strongly defined shadows on her features. This would not be appropriate for the mood I wanted to achieve. Placing the light so it was facing the model directly provided even illumination with few shadows. This suited the intended mood of the shoot.
It is worth noting that I metered and adjusted the lights manually, rather than relying on TTL (through-the-lens) metering and exposure compensation. This allowed me very precise and deliberate control over the relative power of the key and background lights, even though the background light was sometimes firing directly into my lens.
As I wanted the lighting in the image to look natural, I also needed to make sure that the background light (our proxy 'sun') was coming from a plausible angle. This meant raising the light to a location where it didn't seem to be shining through an unlikely gap in the fence, which was otherwise backed by solid vegetation.
|The final look, with post-processing applied. The lens flare artifacts were deliberately left in the image. f2.5, 1/60 @ ISO 200|
Finally, I added some color in post-processing to give the image a warm, pink sunset tone. This was done using a split color filter in Nik Color Efx Pro 3.0. Nik's software allows filter effects to be adjusted in selected areas of an image, such as the skin, with far fewer clicks than traditional masking. In this case, I reduced the effect of the filter on the skin in order to keep the model from getting an atomic suntan.
Beginning to end, this look took about 15 minutes to set up and shoot. Keeping the lighting simple, thinking about the environmental lighting and paying attention to lighting ratios between the flashes and ambient light allowed me to establish a consistent and predictable look very quickly. Best of all, this isn't the type of lighting set that sometimes shows up in photo magazines, where a small truck full of lighting gear and grip equipment is required to get the look. This can easily be done with a pair of external flashes and your neighborhood specialty grocer's alley.
Thomas Park is a fashion / fine art photographer and educator based in Seattle, Washington. To find out more about his work and workshops, please visit http://www.thomasparkphoto.com
Model: Ira Z
All images © 2011, Thomas Park
Sep 26, 2014
Aug 20, 2014
Jun 12, 2014
May 7, 2014
|Steamin' Mad by ahrensjt|
from Angered Subjects (Street Photography)
|Smile by Olymguy|
from Ultra Asian Indian Female Faces
|Space Shuttle Cockpit- by vbuhay|
from Aircraft Control Stick
The Polish town of Katowice is not known as an area of beauty, but as all photographers know, that doesn't mean that beauty can't be found if you know where to look. Mariusz Pietranek used a drone to look down on the colorful sedimentation tanks at an ironworks.
New York Times video journalist Ben Solomon spent a harrowing three weeks accompanying Iraqi Major Sajjad al-Hour as he and his men fought to retake Mosul from I.S. forces.
The 3D VR camera launched through a crowdfunding campaign in 2015 goes on sale beginning June 26.
Noctilucent clouds, a crescent moon and Venus were visible in the pre-dawn sky over Budapest yesterday. Photographer György Soponyai captured NASA's astronomy picture of the day.
Squirming pets won't sit still for photos? A Kickstarter campaign is looking to help.
Find out how Chris Burkard shifted from editorial photography to his true passions: landscapes, conservation and, of course, surfing.
The updated EyeEm app scans your camera roll and picks images that are composed particularly well, have the best quality, or highest chance of selling on EyeEm Market.
It's three years old but still a solid option for a Micro Four Thirds shooter looking for a high-quality, fast, wide-angle prime. Take a look at how we got along with it.
Tamron has announced the longest all-in-one zoom lens currently available, the 18-400mm F3.5-6.3 Di II VC HLD. Designed for Canon and Nikon crop-sensor cameras, the lens will be available in July.
When you're ready to step-up to full-frame from an entry-level or midrange camera, the choices can be overwhelming. Find out which models came out on top in our $1200-2000 enthusiast ILC roundup.
Just a guy wearing a VR headset, smashing invisible Goombas in Central Park.
NASA's Mars Reconnaissance Orbiter captured this gorgeous aerial photo of the Martian landscape. And if you look really close, you can actually see the Mars Curiosity rover in the very middle.
The city of Laguna Beach, California has provided some clarification around the kinds of photography permits it offers.
Later this year, a VR180 camera will be Joining Yi's Halo and 360 VR cameras, which will offer stereo 3D capture, yet be as easy to use and compact as a 2D camera.
Caltech researchers have developed an 'optical phased array' chip that uses time delays instead of a lens to focus the incoming light.
Pricing and shipping have finally been revealed for two highly anticipated lenses from Sigma, announced in February.
These macro photos of clouds of paint billowing through clear water might look like high-quality CGI, but they're real photographs. And photographer Alberto Seveso told us how they were made.
Facebook is testing a feature that prevents people from saving, sharing, or even taking a screenshot of your profile picture.
We've reshot the Sony a9 in our studio. The short story: it's sharper! The long story... well you can read it all here.
The collection will be officially launched during the Europeana Transcribathon Campus Berlin 2017 crowdsourcing event which will be held on 22 and 23 June at the Berlin State Library.
Light gives us some insight into the preparations for the launch of the pre-order shipments of its much anticipated L16 multi-lens camera.
OnePlus co-founder Carl Pei has confirmed in a tweet that the second lens on the back of the OnePlus 5 uses a 1.6x optical zoom and that digital zoom is used to reach the claimed 2x zoom factor.
Fujifilm recently unveiled the second in its series of affordable cine lenses, the MK50-135mm T2.9. We got our hands on it for a couple days and took it for a spin.
Leica's first attempt at an M-series digital rangefinder was rough around the edges, but set a pattern for all of the cameras that came after it. In this week's Throwback Thursday article, Barney remembers the M8.
No stranger to extreme situations, legendary climber and filmmaker Jimmy Chin talks to Outside Magazine about his career, and the challenge of filming Alex Honnold's rope-free solo climb of El Capitain.
A company backed by Android co-founder Andy Rubin is attempting to make video conferencing less terrible.
Rangefinder magazine asked five professional portrait and wedding photographers about posting on Instagram; no surprise, they got five different answers.
This captivating stop motion film was created by stripping away one layer of wood at a time. It's hard to look away.
It will enable users to simulate the presence of the sun, moon and Milky Way and see how they interact with an area's topography.
Since its introduction in November last year Instagram's live streaming feature has been used by millions, but videos could not be archived for watching at a later stage. A new update has now added the capability.