Previous page Next page


Rear of Camera Controls

On the left we have a group of 'digital controls' surrounding the two inch LCD monitor, below this there's a status LCD which again shows information which pertains to the digital side of the camera. On the right is the familiar quick control dial (which can be disabled in record mode but is always active in display or menus), power switch and CF compartment release knob.

On the left side of camera rear (surrounding LCD monitor / LCD status panel):

Button / combination
Protects / un-protects current image.
Hold for 2 seconds: the camera will begin recording a voice annotation (which will be 'attached' to the current image)
No function
Enter / leave camera menu Menu mode: Select menu pages
No function Display mode: Browse through images
Menu mode: Select / change menu options

Enters or leaves display mode (playback) which initially displays the last image taken or browsed to. The EOS-1D is a shooting priority D-SLR which means that it is always read to shoot, a half-press of the shutter release or AE-L button will cancel display mode.

Select display mode:
 • Single image with histogram
 • Single image
 • 2 x 2 thumbnail index
 • 3 x 3 thumbnail index
 • Folder view
Display mode: Show Erase options:
 • OK
 • Cancel
 • ALL
Erase mode: Select one of the three erase options
No function Select image quality / size setting:
 • RAW (or RAW+JPEG)
 • JPEG Large/Fine
 • JPEG Large/Standard
 • JPEG Small/Fine
No function Select white balance setting:
 • Auto
 • Sunny
 • Shade
 • Cloudy
 • Incandescent
 • Fluorescent
 • Flash
 • Custom WB (manual preset)
 • PC-1, PC-2, PC-3 (personal WB)
 • K(elvin) temperature (2800-10000 K)

WB + Display
Show white balance bracketing setting Select white balance bracketing:
 • +/- 1,2 or 3 steps (3 frames)

Quality + WB

Hold for 2 seconds: camera settings reset (everything reverts to defaults apart from custom and personal functions).

No function
MAGNIFY
Display + Assist
Press and hold the DISPLAY button in combination with the AF Assist button (see below) to enter magnify mode. Personal function 30 must be enabled. No function

On right side of camera rear:

Button / combination
Assist button - pressed in combination with AF point select button reverts to a pre-registered AF point. Press in combination with the DISPLAY button to magnify the image in playback mode (Personal function 30 must be set).
AE Lock - lock exposure as it is currently metered, this allows you to then recompose the image and shoot.
Enter AF point select mode:
Main dial dial (top) used to select AF points horizontally, quick command dial (rear) used to select AF points vertically.
Quick control dial switch - enables or disabled quick control dial for shooting mode. When enabled the quick control dial can be used to quickly set exposure compensation. This switch has no effect in menu or playback modes.
Power camera on / off:
 • Speaker icon (camera beeps to confirm AF lock or manual focus accuracy)
 • On (normal powered on mode)
 • Off (camera will continue writing images out of buffer if there are any)

  • C.Fn 4 allows you reprogram the function of the shutter release and AE Lock buttons to various combinations of AF / AE Lock.


Vertical / Portrait hand grip

The EOS-1Ds has an integrated vertical hand grip which runs the length of the base of the camera. There are a number of controls repeated on the vertical grip (in addition to the shutter release): main dial, FEL button, AE Lock button, AF Assist button and the AF point selection button. These controls are normally disabled and can be enabled by turning the vertical grip activation switch (great name) to 'ON'.


Depth-of-field preview

At the front of the camera beside the lens mount (hand grip side) is the EOS-1Ds' depth-of-field preview button. Press this with a small aperture selected (or metered) and the lens will 'stop down' to that aperture allowing you to preview the effective depth of field of the final shot.

Previous page Next page
23
I own it
4
I want it
39
I had it
Discuss in the forums

Comments