-
Thanks for the help.
Ronnie.
-
Sorry, scrap this post. I forgot the 60p applied to the G30. So PD ultra would be fine.
(Still half asleep :) )
Ronnie.
-
Just had a look. I see Ultra supports 50/60p. I have also read there is a difference between NTSC and PAL formats. I see the Vixia G20 is known as Legria G25 here, so maybe different formats will...
-
Thanks a lot for that info (Lance?). Good timing too. I just woke up :)
One thing I dont get is the different shooting formats. My s20 shoots at 50i, and works perfectly with Powerdirector 11. I...
-
I am unsure what the difference is in the sensor between these 2 camcorders. The G20 has a "pro" series 1/3" CMOS sensor, whilst this does not appear to be the case with the XA10.
Can someone...
-
Thanks Bob. From past experience I know that you need to get the profiles/ICC management set up correctly when using Qimage.
Regards
Ronnie.
-
Using Epson paper with the R2000, do the "standard" Epson profiles give good enough results.
I am thinking of getting the R2000, and have to say that I do not know much about creating special...
-
S/be 16 MB card size. While I'm at it, Large jpeg was "fine" Ronnie.
-
Sandisk SDHC extreme 45mb/sec (10). 18 Gig.Ronnie.
-
After asking a similar question about a week ago, I did a quick test after reading this thread. In Raw I easily get 5-6 shots before the camera starts to slow down. +- 23mb files.In large jpeg...
-
Thanks for the help. I can now wait a little longer to splash out on a 95mb/s card. Quite pricey here.Ronnie.
-
I disabled lens aberration corrections, and now it runs no problem. Just wondering if a 95mb/s card would give me the frame rate with lens aberration correction enabled. ThanksRonnie.
-
Thanks Philip. From my 7D experience, those are the first two I disabled. ThanksRonnie.
-
I would try searching the forum, but can't get it to work. I have made sure that all criteria (that I am aware of) are met to ensure max frame rate, except SD card.With a 70-200 F4L at high shutter...
-
Not sure why my post ended as a reply to your post. It was supposed to be a new post as a general comment :)Ronnie
-
I got the G1X recently, and have printed A2 (22x15 to be exact). Even at arm's length the prints are very sharp. Ronnie.
-
Thanks for all the help. The idea of a 270 sounds good because of the size.However, I do have a 430EX, but at first it would not work on the G1X. Hence the question. Following confirmation that it...
-
Great. Thanks for the help Ronnie.
-
The manual only seems to mention the EX11. Does anyone know if the 430EX works on the G1X? ThanksRonnie.
-
Thanks, sounds right.Ronnie.
Activity older than 12 months is not displayed.
|
| Total messages |
826 |
| Threads started |
82 |
| Last post |
54 min ago |
Ronnie Potgieter has not added any dpreview gear yet.
|