wjwncpro_Ds

http://forums.dpreview.com/forums/read.asp?forum=1003&message=41859369

Sakura Pigma Micron http://www.amazon.com/gp/product/B0008G8G8Y/ref=oh_details_o02_s00_i00

I have a waste ink bottle installed, but thanks for your suggestion...

Thanks Vernon for the tip

Check with InkJetMall and Cone Inks, I think they have a flush you can use for long term storage... -- My Pentax galleries http://www.pbase.com/wjwncpro PPG...

Topped off/reset all my carts and put in the empty VM OEM Cart and it reads the VM cart as low on ink which means the printer is A-Ok. I'll shut it down till I receive my cart from Epson tomorrow...

I haven't been doing to good in the luck department lately, but I can always hope!!!Here's what the manual says;If an ink cartridge is low, the ink light flashes and you see a ' ! ' symbol...

Thanks Bob for your reply, I cleaned the pickup sensor and I have to wait about another hour to check it. I'll do the check with my (empty) OEM VM cart to see if the R3000 will recognize it (it...

Thanks Andrew for your reply,I am currently in contact with Ross at Inkjetcarts and he gave me instructions as to what to do to clean up the mess (Ross's reply to follow this). How were you able to...

Thanks Zone8In the middle of all this as I was trying to reply to my 1st post with the pictures, the power went out and didn't come back on till the middle of the night.

we go again, Round II.I printed about 2 dozen prints today, mostly 11x14 on glossy, prints are coming out great including the last one I printed with no problems. I had to refill a couple of carts ...

I print on Velvet Fine Art paper with the R3000, in the print settings change Photo Black ink to 'Mat Black' then you will be able to choose Velvet. You will have to load the Velvet from the front...

Thanks Brian, I'm still in the learning curve stage of printing. So, The only time you would want to go higher than 2880 dpi would be with ultra glossy surfaces. Would high dpi be used for...

Wouldn't the 5760X1400 dpi best be used on the higher quality mat and cotton papers like the Ultra mats or Velvit Fine Art papers???

Here's a quick & easy print drying rack that can be made with cardboard and mat backing. This one is made with 16" x 20" mat board and will hold (11) 13 x 19 prints. I used mat board as I had some...

1st, I use a HP ZR24w display with constant monitoring and calibration using a Spyder 3 Pro.I still have an Epson 1400 which I would always have to print a 4x6 proof section of anything I...

I did just as you instructed below and got it working. I plugged it back in in the morning, did a nozzle check which was spotty and went through the unplug/plug cycle again while I was at work and...

thanks Paul and jtoolman,I've contacted Ross from inkjetcarts and downloaded the purge charts but that did not work. Wasting a lot of ink!!!!!! I've re-installed the drivers re-primed the PK cart,...

I use Inkjetcarts and have refilled the Photo Black ink once and now on the 2nd refill after resetting it is not working. Here's what happened; I did a mat black print last night and today when I...