NEC monitors

Started Jan 19, 2013 | Discussions thread
ronzie
Senior MemberPosts: 1,285
Like?
Re: NEC monitors
In reply to Zee Char, Jan 20, 2013

I think this review will help you find the problem:

http://www.tftcentral.co.uk/reviews/content/nec_2490wwuxi.htm#spectraview

Out of the box the illumination was measured at 380 ft/cd/m2 or nits. It was way too bright and blue difference from the sRGB color space standard was way too high out of permissible spec. Taken down to 140 nits it was well within tolerance.

You also need to decide on what you are going to use for calibration software. The Spectraview products communicate with the controls anf color look up table. You first set the video card for its standard defaults. Set the monitor for user RGB default reset. Any auto contrast, etc., should be disabled. Then you run the SV software choosing your illumination (best around 120 if you are going to print) and reference color temperature. D65 is common. You make sure ambient light minimally falls on the screen. (On my NEC P221W I have that compensation for brightness disabled.) Then the software will set brightness (of the backlight), and then the LUT's (color look up table in the monitor itself) and create a color profile for your operating system to use as well. The software if you wish can load the monitor LUTs and settings every time you start up your PC.

With 40,000 hours on the monitor you might be getting the aging CCFL backlights to dimming color temperature shifting point easily over driven at too high brightness. You also have to watch out that you are not having the video driver color settings fighting the monitor settings and backlight aging so that the color channels in each are not being over driven. The fact that your color shifts as illumination is reduced indicates one or both of these is taking place.

The Spyder series just adjusts the video card, thus the monitor needs to be manually set up correctly first.

Finally the review shows the monitor should fit very nicely the sRGB color space.

I suggest you look at the color management topics in the printer forum.

I can't find the monitor on the NEC site but from that review it looks like it is not a wide gamut monitor but standard intended for sRGB color space.

As I recall from the Spectraview II FAQ NEC does not recommend using the Spyder measuring devices with their Spectraview software having found to many discrepancies if that was your plan.

The review article uses different calibration software that does communicate with the monitor LUT as well as Spectraview.

-- hide signature --

Ron Ginsberg
Minneapolis, MN
Land of 10,000 Puddles

Reply   Reply with quote   Complain
Post (hide subjects)Posted by
Keyboard shortcuts:
FForum PPrevious NNext WNext unread UUpvote SSubscribe RReply QQuote BBookmark post MMy threads
Color scheme? Blue / Yellow